Harrop designed lower manifold incorporates TVS2650 rotating group proven to be 1200+hp capable
Bypass Air is Intercooled to reduce heat circulation and further improve IAT’s
Billet drive assembly runs LSA secondary belt FEAD allowing a wide range of pulley combinations
Throttle body adaptor is separate from the input drive and allows fitment of up to 103mm throttle body or can be replaced with our 115mm integrated throttle body.
Harrop o-ringed thermal manifold insulators remove heat transfer through manifold to cylinder head contact
Compatible with the factory LSA lid, intercooler, fuel rails and all factory sensors or the Harrop performance LSA lid upgrade
Building on our comprehensive modular Supercharger range available for the popular LS engine platform, the new H2650i is designed as a direct replacement for the factory LSA1900 Supercharger. The new lower manifold incorporates the highly efficient TVS2650 rotating group from Eaton and is engineered to utilize the factory LSA lid, fuel rails and sensors or the Harrop performance lid upgrade.
The factory throttle body position is maintained to ensure correct alignment with existing air intakes. The H2650i will accept up to a 103mm bolt on throttle body and can also be ordered with the new extreme flow 115mm integrated throttle body.
Retaining a factory look whilst giving 1200hp+ capability will appeal to both factory LSA cars and engineered LSA engine swap owners alike, wanting to retain the LSA engine look and keep their upgrades discrete.
LSA engine variants
Chevy ZL1 Camaro (2010-2015)
Cadillac CTS-V (2009-2014)
|Item#||Status||Description||Qty.||Retail Price||MSRP||Your Price|
LSA-H2650i Supercharger Kit
ADD TO CART
Products sold without calibration require the consumer and installer take on the responsibility to tune the vehicle on a reasonable basis for emissions compliance. Products provided with no calibration are not eligible for supplemental warranty and are not legal for use in the state of California. Please visit the SEMA emissions page to check your local emission requirements.
Kits sold with calibration are CARB compliant for use in California and 50 state legal, any kits sold outside of the USA will require the end consumer to check and verify emission compliance with there local laws and regulations. It is the responsibility of the installer and end user to ensure that this product is being used within compliance of all applicable laws and regulations.
There are no featured galleries matching this product.
You’ll be first to know about Harrop products, discounts and special events!